In Mixer, we choose a spare channel, in my case I chose Channel 7. I call it “rssi”, and choose “RSSI” as the source. Configuration on Taranis – RSSI value in PPM Channel The setup is the same for both Taranis X9D and QX7. Finally you can setup the MinimOSD to get RSSI reading from Cleanflight, and display it. Then you can configure your Cleanflight to recognise this channel as RSSI value. If you are running PPM, and has a spare channel, you can assign this channel RSSI and send it back to your RX. It changes very infrequently, and basically only jumps between 0 and 100.Īlso RSSI pads on the receiver often tend to be very small and difficult to solder to.Īpart from getting this info from the telemetry port, I also recently found another way of getting RSSI value, which is more accurate, and no additional wire and soldering. I didn’t use one and just connect them directly, it works, but the RSSI data is pretty inaccurate I must say. However one since the RSSI signal is PWM, a digital form, you need a low pass filter to convert it into analogue voltage level.
0 Comments
Leave a Reply. |